Din Rail Installation; Figure 14: Orientation Of The Switch On A Din Rail; Figure 15: Install Top Slot Of Din Rail Bracket Onto Din Rail - Allied Telesis IS Series Installation Manual

Chapter 3: Install the Switch

DIN Rail Installation

54
The switch comes with a DIN rail bracket pre-installed on the back panel.
The bracket is compatible with a DIN 35x7.5mm rail. The bracket has a
spring built into it which holds the bracket in place. Figure 14 shows the
proper orientation of the switch on a DIN rail. Do not install the switch
horizontally or upside-down.
Figure 14. Orientation of the Switch on a DIN Rail
To install the switch on a DIN rail, perform the following procedure:
1. Slide the slot on the top of the DIN rail bracket onto the top edge of the
DIN rail. Refer to Figure 15.
Figure 15. Install Top Slot of DIN Rail Bracket onto DIN Rail
TOP Slot in DIN
rail bracket
Top edge of DIN
rail