Table of Contents
Advertisement
Chapter 5: Power On Switch
Connect Ground Wire
68
Here are the guidelines for the ground wire:
Warning
Take into consideration the following guidelines before wiring the
device.
Attention
Tenez compte des directives suivantes avant de câbler l'appareil.
The terminal block (CN1) is suitable for 12-18 AWG (7A). Torque
value 7 lb-in.
Le bornier (CN1) est adapté pour 12-18AWG (3,31-0,205mm²).
Valeur de Torgue 7lb-in.
The cross sectional area of the earthing conductors should be at
least 0.205 mm.
Le min. La section du conducteur de protection doit correspondre
au conducteur de puissance dans une plage de 3,31-0,205 mm².
The temperature rating of the input connection cable should be
higher than 105
La température nominale du câble de connexion d'entrée doit être
supérieure à 105
Warning
This equipment must be earthed. The ground screw on the unit must
be connected to a properly earthed bonding point.
To connect the grounding wire, perform the following procedure:
1. Strip 2.54cm (1.0 in.) of insulation from the end of the solid grounding
wire with a wire insulator stripper. Refer to Figure 25.
Figure 25. Strip Grounding Wire
Warning
Do not strip more than the recommended amount of wire. Stripping
more than the recommended amount can create a safety hazard by
leaving exposed wire on the terminal block after installation. E10
o
C.
o
C.
2.54cm
(1.0 in.)
Advertisement
Table of Contents
