Table of Contents
Advertisement
Reset Button
The Reset button resets the switch. You might reset the switch if it is
experiencing a problem. The reset button is recessed in the chassis. To
press it, use a straightened paper clip or similar object.
The switch behaves as follows:
Hold it for 5 sec: The switch software will reboot and return the
configuration settings to factory defaults.
Hold it for 2 sec: The switch software will reboot and keep the
existing configuration settings that have been previously saved.
Caution
The switch does not forward network traffic for approximately one
minute while it initializes its management operating system. Some
network traffic may be lost.
Note
Unsaved changes to the configuration settings of the switch are
discarded when you reset the device.
IS230-10GP Industrial Ethernet Layer 2 Switch Installation Guide
31
Advertisement
Table of Contents
