Chapter 5: Power On Switch
72
2. Tightly wrap the wire strands with your finger tips. Refer to Figure 30
on page 72.
This step is to prevent loose strands from touching other wires and
causing an electrical short.
Note
Allied Telesis recommends that you also tin the wires with solder as
added protection against loose strands. This guide does not provide
instructions on how to tin wires.
3. Loosen the two fastening screws on the ends of the Power/Alarm
connector . Remove the power/alarm connector from the top panel.
Figure 31 shows the removal of this connector.
Figure 31. Remove Power/Alarm Connector
Figure 30. Wrap Wire Strands