Table of Contents
Advertisement
2. Press down (against the spring within the bracket) on the top back
edge of the switch until you the bottom edge of the front faceplate of
the switch can be pushed back and under the bottom edge of the DIN
rail. Release the pressure on the top of the switch until the DIN rail
bracket spring securely fastens bracket to the top and bottom of the
DIN rail. Refer to Figure 16.
Figure 16. Install Switch on DIN Rail
3. Visually inspect the bracket to verify that the DIN rail is now fitted into
the top and bottom slots of the DIN rail bracket.
4. Go to Chapter 4, "Install Twisted-Pair Ports Cables" on page 61.
IS230-10GP Industrial Ethernet Layer 2 Switch Installation Guide
55
Advertisement
Table of Contents
