Table of Contents
Advertisement
Power Supplies
Allied Telesis does not sell power supplies for these products. Power
supplies can be purchased from power supply manufacturers.
Note
This product is intended to be supplied by a UL61010 OR
UL61010-2-201 and 60950-1 or 62368-1 Listed DC power source,
rated 24-48Vdc, 7A minimum and Tma 75 degree C. If you need
further assistance, please contact Allied Telesis for further
information.
Le commutateur doit etre homologuee selon les normes UL61010
ou UL61010-2-201 et UL 60950-1 ou UL62368-1 et alimentes par un
courant de sortie de 24-48Vdc, 7A minimum, et temperature
ambiante maximale (Tma) 75 degres.
Here are the power supply requirements for the IS230-10GP switch:
DC voltage between 24 and 48 VDC.
Tension continue entre 24 et 48 VDC.
The DC power supply must be capable of supplying 7A
continuously over the operating temperature range of
-40° C to 75° C (-40° F to 167° F).
L'alimentation CC doit être capable de fournir 7A en continu dans
la plage de températures de fonctionnement de
-40° C à 75° C (-40° F à 167° F).
Note
See "Power Specifications" on page 88 for the DC power supply
output requirements.
A single power supply that meets the above requirements can fully power
the switch. A second power supply can also be connected for power
redundancy.
Power supplies are connected to four of the six terminals on the
power/alarm connector on the top panel of the chassis. Refer to
Figure 8 on page 40. Each power supply is connected to the switch with
two wires, one positive (+) and one negative (-). If you are installing only
one power supply to the switch, you may connect it to either the PWR 1 or
PWR 2 pins.
IS230-10GP Industrial Ethernet Layer 2 Switch Installation Guide
39
Advertisement
Table of Contents
