Unit Installation; Preparing The Installation Site; Installation Site Requirements Of The Indoor Unit - Daikin Altherma 3 GEO Series Installer's Reference Manual

6 Unit installation

6.1 Preparing the installation site

6.1.1 Installation site requirements of the indoor unit

EGSAH/X06+10UDA9W
Daikin Altherma 3 GEO
4P598592-1A – 2019.12
Do NOT install the unit in places often used as work place. In case of construction
works (e.g. grinding works) where a lot of dust is created, the unit MUST be
covered.
Choose an installation location with sufficient space for carrying the unit in and out
of the site.
WARNING
The appliance shall be stored in a room without continuously operating ignition
sources (example: open flames, an operating gas appliance or an operating electric
heater).
INFORMATION
Also read the precautions and requirements in the "General safety precautions"
chapter.
▪ Mind the following spacing installation guidelines:
≥500
INFORMATION
If you have limited installation space and need to install the option kit EKGSPOWCAB
(= power cable for split power supply), remove the left side panel before installing
the unit in its final position. See
▪ The indoor unit is designed for indoor installation only and for ambient
temperatures ranging from 5~35°C.
▪ The foundation must be strong enough to bear the weight of the unit. Take the
weight of the unit with a domestic hot water tank full of water into account.
Make sure, in the event of a water leak, water cannot cause any damage to the
installation space and surroundings.
Do NOT install the unit in places such as:
▪ In places where a mineral oil mist, spray or vapour may be present in the
atmosphere. Plastic parts may deteriorate and fall off or cause water leakage.
▪ Sound sensitive areas (e.g. near a bedroom), so that the operation noise will
cause no trouble.
▪ In places with high humidity (max. RH=85%), for example a bathroom.
50
≥650
(mm)
"6.2.2 To open the indoor
6 Unit installation
|
4
unit" [ 55].
Installer reference guide
53