About The Box; Outdoor Unit; To Remove The Accessories From The Outdoor Unit; Unit Installation - Daikin EWAA008D2V3P-H Installation Manual

Packaged air-cooled water chillers and packaged air to water heat pumps
Hide thumbs Also See for EWAA008D2V3P-H:
Table of Contents

Advertisement

3 About the box

WARNING
The backup heater MUST have a dedicated power supply
and MUST be protected by the safety devices required by
the applicable legislation.
CAUTION
To guarantee the unit is completely earthed, ALWAYS
connect the backup heater power supply and the earth
cable.
WARNING
Stripped wire. Make sure that stripped wire cannot make
contact with possible water on the bottom plate.
Commissioning (see "9 Commissioning" [ 4  35])
WARNING
Commissioning method MUST be in accordance with the
instructions
from
"9 Commissioning" [ 4  35].
3
About the box
Keep the following in mind:
▪ At delivery, the unit MUST be checked for damage and
completeness. Any damage or missing parts MUST be reported
immediately to the claims agent of the carrier.
▪ Bring the packed unit as close as possible to its final installation
position to prevent damage during transport.
▪ Prepare in advance the path along which you want to bring the
unit to its final installation position.
3.1

Outdoor unit

3.1.1
To remove the accessories from the
outdoor unit
1 Remove the accessories on top and in front of the unit.
a
b
c
a
Installation manual vibration dampers
b
General safety precautions
c
Operation manual
d
Installation manual
e
Addendum book for optional equipment
f
Energy label
Installation manual
8
this
manual.
See
d
e
f
g
h
i
j
k
g
User interface (front plate, rear plate, screws, and wall
plugs)
h
Unit mounting plate
i
Vibration dampers
j
Cable tie
k
Bolts, nuts, washers, and spring washers
2 After opening the unit (see
unit" [ 4  11]), remove the accessory inside the unit.
m
m
Shutoff valve
4

Unit installation

4.1

Preparing the installation site

WARNING
The appliance shall be stored so as to prevent mechanical
damage and in a well-ventilated room without continuously
operating ignition sources (example: open flames, an
operating gas appliance or an operating electric heater).
4.1.1
Installation site requirements of the
outdoor unit
Mind the following spacing guidelines:
b
>
30
0
a
≥500
(mm)
>
30
0
>350
b
a
(mm)
a
Air outlet
b
Air inlet
The outdoor unit is designed for outdoor installation only, and for the
following ambient temperatures:
Cooling mode
10~43°C
Heating mode
–25~25°C
Mind the measurement guidelines:
Maximum distance between outdoor unit and
external backup heater kit
"4.3.1  To open the outdoor
b
>
30
0
a
>250
(mm)
10 m
EWAA004~008D + EWYA004~008D
Packaged air-cooled water chillers
and packaged air to water heat pumps
4P688014-1D – 2022.10

Advertisement

Table of Contents
loading

Table of Contents