To Connect The Electricity Meters; To Connect The Domestic Hot Water Pump - Daikin Altherma 3 GEO Series Installer's Reference Manual

8 | Electrical installation

8.2.4 To connect the electricity meters

8.2.5 To connect the domestic hot water pump

Installer reference guide
90
3 Fix the cable with cable ties to the cable tie mountings.
Wires: 2 (per meter)×0.75 mm²
Electricity meters: 12 V DC pulse detection (voltage supplied by PCB)
[9.A] Energy metering
INFORMATION
In case of an electricity meter with transistor output, check the polarity. The positive
polarity MUST be connected to X5M/6 and X5M/4; the negative polarity to X5M/5
and X5M/3.
1 Open the following (see
1 Top panel
2 User interface panel
3 Installer switch box cover
2 Connect the electricity meters cable to the appropriate terminals as shown in
the illustration below.
3 Fix the cable with cable ties to the cable tie mountings.
Wires: (2+GND)×0.75 mm²
DHW pump output. Maximum load: 2 A (inrush), 230 V AC, 1 A
(continuous)
[9.2.2] DHW pump
[9.2.3] DHW pump schedule
"6.2.2 To open the indoor
S3S S2S
2×
1×
X5M
1×
4
unit" [ 55]):
1
3
2
EGSAH/X06+10UDA9W
Daikin Altherma 3 GEO
4P598592-1A – 2019.12