Run Boxes To Check Adjustment - 3M -MATIC 8000a-T Instructions Manual

11 - SET UP AND ADJUSTMENTS (continued)
11.5 Special Set-Up Procedure for Outer Column Re-Positioning (continued)
Moving the outer columns will increase or decrease
the box height handled by the 8000a-8000a3
case sealer. Figure 11-8
Maximum Height:
An additional adjustment can be made to reach
Maximum Height. This additional height adjustment
can be made by moving the Upper Assembly Crossbar
up to top holes - (Figure 11-8).

11.6 Run Boxes to Check Adjustment

Turn electrical switch "On" (I) to start drive belts.
Move box forward under upper taping head until it is
taken away by drive belts. If box is hard to move
under head or is crushed, raise head slightly.
If the box movement is jerky or stops under the upper
head, move the side drive belts in slightly to add more
pressure between the box and drive belts.
Important – If drive belts are allowed to slip on
box, excessive belt wear will occur.
2014 June
8000a-8000a3 - NA
26