12-OPERATION
12.1 Operator's Correct Working Position and
Operational Flow (Figure 12-1).
Figure 12-1
Once the box has been
fi lled, close its top fl aps and
push it between the top and
bottom drive belts. Always
keep hands in position as
shown in Figure 12-2.
The box will be automatically
sealed with adhesive tape
on the top and bottom box
seams. Then the box will be
expelled on the
exit conveyor.
12.2 Starting the Machine
Important: Before starting the machine, verify that
no tools or other objects are on the conveyor bed.
Push the main switch ON (I) after the
EMERGENCY BUTTON is released (Figure 12-3).
Figure 12-3
700r3-NA
Hand Position
Figure 12-2
39
12.3 Starting Production
Let the machine run without cartons and check its
safety devices. Then start the working cycle.
12.4 Tape Replacement and Threading
Skill 1 - Operator
See Manual 2:
AccuGlide™ 3 Taping Heads - 3 inch.
Press the
LATCHING EMERGENCY STOP BUTTON.
WARNING
•
To reduce the risk associated with sharp
blade hazards:
−
Keep hands and fi ngers away from tape
cutoff blades under orange blade guards.
The blades are extremely sharp.
12.5 Box Size Adjustment
Repeat all the operations shown in
Section 11 - Setup and Adjustments.
12.6 Cleaning
Before carrying out any cleaning or maintenance
operation stop the machine by turning the OFF (O)
switch on the main and disconnect the
electric power (Figure 12-3).
12.7 Table of Operation Adjustments -
Operator Qualifications
1 Tape loading and threading
2 Tape web alignment
3 Adjustment of one way tension roller
4 Adjustment to box size (H and W)
5 Top fl ap compression rollers
6 Adjustment of tape applying spring
7 Conveyor bed height adjustment
8 Special Adjustment-Changing tape leg length 2
9 Special Adjustment-Column re-positioning
12.8 Safety Devices Inspection
1 Taping units blade guard
2 Latching emergency stop button
3 STOP (OFF) (O) main switch
1
1
1
1
1
1
1
2
2012 January