Tm54F Terminal Module - Siemens SIMOTION D410 PN Manual

7.3

TM54F terminal module

Features of the TM54F
The TM54F Terminal Module is a terminal expansion module for snapping on to a DIN EN
60715 mounting rail. The TM54F offers safe digital inputs and outputs for controlling
SINAMICS Safety Integrated functions and is supported by SIMOTION D410, V4.1 SP2 and
higher.
A SIMOTION D410 can be assigned exactly one TM54F, which is connected via DRIVE-
CLiQ. Additional nodes (e.g. TMxx, SMxx) can be connected to the same DRIVE-CLiQ line.
Table 7- 3
Type
Fail-safe digital outputs (F-DO)
Fail-safe digital inputs (F-DI)
Sensor
Sensor
Digital inputs for testing the F-DO during test stop
1)
2)
The TM54F provides 4 fail-safe digital outputs and 10 fail-safe digital inputs. A fail-safe
digital output consists of a P/M-switching output as well as a digital input for reading back the
switching state. A fail-safe digital input is made up of two digital inputs.
The 50 mm clearances above and below the components must be observed.
Additional references
You will find detailed information about the TM54F Terminal Module in the
Safety Integrated
SIMOTION D410
Manual, 02/2012
The following terminals are located on the TM54F:
power supplies, dynamization supported
1)
power supply, no dynamization
1)
Sensors: Fail-safe devices for commanding and detecting, such as emergency stop pushbuttons
and safety locks as well as position switches and light arrays / light curtains.
Dynamic response: The sensor power supply is switched on and off during test stop for testing the
sensors, the cable routing, and the evaluation electronics of TM54F.
CAUTION
Function Manual.
7.3 TM54F terminal module
2)
Spare parts/Accessories
Quantity
4
10
2
1
4
SINAMICS S120
91