Siemens SIMOTION D410 PN Manual page 23

Interfaces
The SIMOTION D410 PN interfaces are described in the following tables.
Table 1- 6
Interface
Digital inputs/outputs
X121
DRIVE-CLiQ interface
X100
PROFINET interface
(ports X200 and X201)
Power Module Interface
(PM-IF)
Encoder interface (HTL / TTL /
SSI)
X23
EP terminals/temperature
sensor connection
X120
Power supply connection
X124
Measuring sockets
T0, T1, T2 and M
Type plates
The figure below shows all the information included on the type plate located on the side of
the unit.
Figure 1-6
SIMOTION D410
Manual, 02/2012
SIMOTION D410 interfaces
Description
12-pin Mini Combicon:
4 digital inputs: for connecting switches and proximity sensors
•
4 digital inputs/outputs: for connecting actuators and sensors
•
8-pin RJ45plus socket to connect DRIVE-CLiQ nodes
8-pin RJ45plus socket to connect to PROFINET
8-pin direct connector to connect to a blocksize power module
15-pin SUB-D socket for connecting HTL, TTL and SSI encoders.
8-pin Mini Combicon for connecting Safety Integrated input
terminals or for connecting temperature sensing via KTY or PTC
4-pin screw terminal connection to connect the 24 V DC load
power supply
Sockets to output analog signals
SIMOTION D410 PN type plate
1.4 SIMOTION D410 PN display
Module designation
Order number
Serial number
HW version
Description
23