Ethernet Powerlink; Pc-Software; System Requirements - Danfoss VLT ISD 510 Design Manual

System Overview
2 2 X1
X2
1 Ports always connected internally in the SAB.
X1 RJ45 cable connector to the PLC or previous slave.
X2 RJ45 cable connector to the PLC or next slave.
X3 M23 feed-in cable to the 1
connector.
X4 M23 feed-in cable to the 1
connector.
Illustration 2.13 EtherCAT
Line Topology Mode (default)

2.8.1.2 Ethernet POWERLINK

The servo drive and the SAB are certified according to
DS301 V1.1.0. The following features are supported for the
servo drive and the SAB:
•
Work as controlled node.
•
Can be operated as multiplexed stations.
•
Support of cross-communication.
•
Ring redundancy is supported for media
redundancy.
Specific ports are not assigned for Ethernet POWERLINK

2.8.2 PC-Software

The DDS Toolbox is a standalone PC software designed by
Danfoss. It is used for parameterization and diagnostics of
the servo drives and the SAB and can also be used to
operate the devices in a non-productive environment. The
DDS Toolbox contains several functionalities, called sub-
tools, which in turn provide various functionalities.
The most important sub-tools are:
•
Scope for visualization of the tracing functionality
of the servo drives and SAB.
•
Parameter list for reading/writing parameters.
•
Firmware update
•
ISD 500 Drive control/SAB control to operate the
servo drives and/or SAB for testing purposes.
22
®
VLT Integrated Servo Drive ISD
ESC SAB L1
R
Main EtherCAT
X3
slave
OUT
Port 2 (C)
1
IN
Port 0 (A)
ESC SAB L2
AL emulated
X4
junction slave
st servo drive on line 1 with RJ45
st servo drive on line 2 with RJ45
®
Port Assignment for the SAB in
®
Danfoss A/S © 08/2017 All rights reserved.
®
510 System
•
CAM editor for designing CAM profiles for the
servo drives.
The detailed description of the DDS Toolbox functionality
and the full parameter lists can be found in the VLT
Integrated Servo Drive ISD

2.8.2.1 System Requirements

To install the DDS Toolbox software, the PC must meet the
following requirements:
•
Supported hardware platforms: 32-bit, 64-bit.
•
Supported operating systems: Microsoft
Windows XP Service Pack 3, Windows 7, Windows
8.1.
•
.NET framework version: 3.5 Service Pack 1.
•
Minimum hardware requirements: 512 MB RAM,
Intel Pentium 4 with 2.6 GHz or equivalent, 40 MB
hard disk space.
•
Recommended hardware requirements: Minimum
1 GB RAM, Intel Core i5/i7 or compatible.
®
.
®
®
510 System Programming Guide.
®
MG36C102