Table of Contents
Advertisement
Page 4-5
4.4
Clean Laminator Tab
To Clean the Printer:
1.
Remove all cards from the Card Hopper.
2. Take out the ribbon drawer and remove the ribbon.
3. Reinsert the empty ribbon drawer.
4. Remove the paper backing from both sides of the Cleaning Card. Note: DO NOT remove small
liner strip if a magnetic encoding module is installed in your printer.
5. Insert the Cleaning Card into the Card Hopper's in-feed rollers. See the diagram below.
6. Click the Clean button below.
7.
Guide the Cleaning Card into the printer if necessary.
8. When the Cleaning routine is complete, the Cleaning Card will exit the printer.
9. Take out the ribbon drawer and reinstall the ribbon.
10. Reinsert the ribbon drawer into the printer.
Note: The Cleaning routine will begin after all current print jobs have completed. A standard CR80
size cleaning card must be used.
May 2017
ToolBox
PLT-02496, Version: 1.2
Advertisement
Table of Contents
Troubleshooting
