HID FARGO DTC 5500LMX User Manual page 64

Error Message Cause
#356
The Laminator has reported a
Laminator General
general fault.
Error
#357
The Laminator has reported a
Laminator General
general fault.
Error
#358
The Laminator has reported a
LAM1 Laminate
general fault.
Not At TOF
#359
The Laminator has reported a
LAM2 Laminate
general fault.
Not At TOF
#360
The Laminator has reported a
LAM1 Laminate
general fault.
Not Ready
#361
The Laminator has reported a
LAM2 Laminate
general fault.
Not Ready
#362
The Laminator has reported a
Laminator General
general fault.
Error
#363
The Laminator is unable to
calibrate the LAM1 laminate load
Laminator
sensor.
Calibration Error
#364
The Laminator is unable to
calibrate the LAM2 laminate load
Laminator
sensor.
Calibration Error
#365
The Laminator is unable to
calibrate the LAM1 laminate
Laminator
position sensor.
Calibration Error
#366
The Laminator is unable to
calibrate the LAM2 laminate
Laminator
position sensor.
Calibration Error
PLT-02496, Version: 1.2
Troubleshooting
Solution
Ensure that the laminate material is properly installed. Clear
any cards in the Laminator Module by using the manual feed
on the Laminator. Press the Resume button to continue. To
cancel, press the Cancel Print button or the Cancel button
located on the Printer.
Ensure that the laminate material is properly installed. Clear
any cards in the Laminator Module by using the manual feed
on the Laminator. Press the Resume button to continue. To
cancel, press the Cancel Print button or the Cancel button
located on the Printer.
Ensure that the laminate material is properly installed. Clear
any cards in the Laminator Module by using the manual feed
on the Laminator. Press the Resume button to continue. To
cancel, press the Cancel Print button or the Cancel button
located on the Printer.
Ensure that the laminate material is properly installed. Clear
any cards in the Laminator Module by using the manual feed
on the Laminator. Press the Resume button to continue. To
cancel, press the Cancel Print button or the Cancel button
located on the Printer.
Ensure that the laminate material is properly installed. Clear
any cards in the Laminator Module by using the manual feed
on the Laminator. Press the Resume button to continue. To
cancel, press the Cancel Print button or the Cancel button
located on the Printer.
Ensure that the laminate material is properly installed. Clear
any cards in the Laminator Module by using the manual feed
on the Laminator. Press the Resume button to continue. To
cancel, press the Cancel Print button or the Cancel button
located on the Printer.
Cycle power to system. If the error persists, contact Technical
Support.
Ensure that the LAM1 laminate material is properly installed
and covering the LAM1 laminate sensors. Clear any cards in
the Laminator. Press the Resume button to continue. If the
error persists contact, Technical Support.
Ensure that the LAM2 laminate material is properly installed
and covering the LAM2 laminate sensors. Clear any cards in
the Laminator. Press the Resume button to continue. If the
error persists, contact Technical Support.
Ensure that the LAM1 laminate material is properly installed
and covering the LAM1 laminate sensors. Clear any cards in
the Laminator. Press the Resume button to continue. If the
error persists, contact Technical Support.
Ensure that the LAM2 laminate material is properly installed
and covering the LAM2 laminate sensors. Clear any cards in
the Laminator. Press the Resume button to continue. If the
error persists, contact Technical Support.
Page 5-10
May 2017