Graco ProControl 1KE Plus Instructions-Parts List Manual page 37

Fill Fill Fill Mode Mode Operation Mode Operation Operation
The data used to operate Fill Mode is configured in
Setup Screen 11: Fill Mode, page
When Fill Mode is activated, the fluid regulator is set
to the percentage drive value from the setup screen.
The atomizing air regulator is set to zero. This runs
for the selected amount of time. The fluid volume
that flowed during the fill process is compared to the
minimum fill volume from the setup screen. If the
volume was not achieved, the "SN" alarm is activated.
Table 4 4 4 Fill Fill Mode Mode Run Run Screens
Table Table Fill Mode Run
Description Examples
Description Description Examples Examples
Fill Mode active
Fill Mode
complete
3A6948A
51.
Screens
Screens
The following icons are available on the Run Screen
in Fill Mode:
Enter the screen.
Atomizing air regulator
Flow rate target
Current fluid pressure
Fill Mode – No flow detected
Fill Mode Countdown Timer
Move between Run Screens.
Run Screens
Key
Key Key
37