Setup Screen 8: Operator Input Limits - Graco ProControl 1KE Plus Instructions-Parts List Manual

Setup Screen Screen 8: 8: 8: Operator
Setup Setup Screen
This screen changes format and data
based on the Control Method. See
Control Method Considerations, page
more information.
Table 12 Table Table 12 Setup 12 Setup Screen Setup Screen Screen 8 8 8 Operator
Description Description Description
Monitor and Accumulate Volume Only
Closed-Loop Pressure Control
Closed-Loop Flow Control
Open-Loop Current Setpoint
Enter the screen to set or change
preferences.
Press to activate a field for editing or
to accept the highlighted selection on a
menu.
Move to the right when editing number
fields. Press again to accept the entry
when all digits are correct.
Set your desired maximum (first data
field) and minimum (second data field)
pressure when in pressure control mode.
The system's Pressure Target will not be
allowed to be set outside of this range.
3A6948A
Operator Input Input Limits Limits
Operator Input Limits
32, for
Operator Input Operator Input Limit Input Limit Limit Examples Examples Examples by by
Setup Screen
Setup Setup
Note
There are no input limits
for the Open-Loop
Current Setpoint
method.
Key
Key Key
The following table demonstrates how operator input
limits may be set for the setpoints on the Run screen.
Note
These are not alarm limits.
by Control Control Method Control Method Method
Screen 8 8 8 Example Example
Screen Example
Set your desired maximum (first data
field) and minimum (second data field)
flow rate when in flow control mode. The
system's Flow Rate Target will not be
allowed to be set outside of this range.
Exit data editing.
Move between Setup Screens, fields on
a screen, or to increment/decrement the
digits when editing number fields.
Setup Screens
Run Screen Screen Example Example
Run Run Screen Example
Key
Key Key
49