Run Screens; Screen 1: Run Operations - Graco ProControl 1KE Plus Instructions-Parts List Manual

Run Screens

Run Screens Screens
Run Run Screens
Screen 1: 1: 1: Run Run Operations Operations
Screen Screen Run Operations
Run Run Run Mode Mode Selection Mode Selection Selection
There are four Run modes that can be selected from
the Run screen.
1. Press the softkey next to the Mode Selection
icon.
2. Select one of the following mode icons from
following table.
Icon Description
Icon Icon Description Description
Standby Mode – depressurize system
• Gun atomizing air pressure is set to 0
• Fluid pressure is set to 0
Flush Mode – used for solvent flush
• Gun atomizing air pressure is set to 0
• Fluid pressure is set to a percent value
(see Setup Screen 12: Flush Mode,
page 52)
34
Icon Icon Icon Description Description Description
Fill Mode – used for loading paint
• Gun atomizing air pressure is set to 0
• Fluid pressure is set to
a percent value (see
Setup Screen 11: Fill Mode, page
Dispense Mode – used for painting
• Gun atomizing air pressure is set to
the target percent value
• Fluid pressure is set to either the flow
or pressure target
Dispense Mode – gain reset
• This is used to put the system back
into "high gain" mode where it will
rapidly attempt to correct any off-target
flow situation.
51)
3A6948A