Graco ProControl 1KE Plus Instructions-Parts List Manual page 36

Run Screens
Flush Flush Flush Mode Mode Operation Mode Operation Operation
The data used to operate Flush Mode is configured
in Setup Screen 12: Flush Mode, page
When Flush Mode is activated, the fluid regulator
is set to the percentage drive value from the setup
screen. The atomizing air regulator is set to zero.
This runs for the selected amount of time. The
fluid volume that flowed during the flush process is
compared to the minimum flush volume from the
setup screen. If the volume was not achieved, the
"SP" alarm is activated. The fluid volume is tracked
as a solvent in the Job Log.
Table 3 3 3 Flush Flush Mode Mode Run Run Screens
Table Table Flush Mode Run
Description Examples
Description Description Examples Examples
Flush Mode
active
Flush Mode
complete
36
52.
Screens
Screens
The following icons are available on the Run Screen
in Flush Mode:
Enter the screen.
Atomizing air regulator
Flow rate target
Current fluid pressure
Flush Mode – No flow detected
Flush Mode Countdown Timer
Move between Run Screens.
Key
Key Key
3A6948A