Graco ProControl 1KE Plus Instructions-Parts List Manual page 57

Icon
Code Code Code Icon Icon Summary Summary Summary
SN Minimum
Fill
Volume
SP Minimum
Flush
Volume
B4 Job
Dispense
High
B1 Job
Dispense
Low
F6 Runaway
Flow
P6 Runaway
Pressure
EU System
Idle
MF Mainte-
nance
Counter
G2 Gun Off
Setpoint
3A6948A
Deviations and
Deviations Deviations
Description
Description Description
Alarm only. Active when the
user-set fill volume is not achieved
in a fill cycle.
Alarm only. Active when the
user-set flush volume is not
achieved in a flush cycle.
Alarm only. Active when the
logged job spray volume is more
than the threshold setpoint.
Alarm only. Active when the
logged job spray volume is less
than the threshold setpoint.
Deviation only. Active when using
flow control and the flow target is
not achievable.
Deviation only. Active when using
pressure or flow control and the
pressure target is not achievable.
Advisory only. Active when in
Dispense mode and the gun
trigger has not been activated for
the user-set timeout time. Fluid
pressure is dropped to zero.
Advisory only. Active when the
maintenance totalizer reaches the
user-set maintenance target.
Advisory only. The flow rate
setpoint was changed to a lower
value while the gun was off.
Instead of predicting a pressure
target, the system will predict a
current output target to the I/P. It
may take extra time to stabilize in
this situation.
and Advisories Advisories
and Advisories
Increase fill drive percentage,
fill time, or check fluid supply
( Setup Screen 10: PID Data, page
Press
Increase flush drive percentage,
flush time, or check fluid supply
( Setup Screen 11: Fill Mode, page
Press
Adjust flow rate, spray time, maximum
volume limit, or disable alarm
( Setup Screen 1: Job Target, page
Press
Adjust flow rate, spray time, minimum
volume limit, or disable alarm
( Setup Screen 1: Job Target, page
Press
Determine cause of fluid control failure.
Press
Determine cause of fluid control failure.
Press
Dispense pressure will resume immediately
once the gun trigger is activated. The
advisory will automatically clear. Press
to clear alarm.
Perform maintenance. Reset to zero
using (
Totalizer, page
alarm.
Activate spraying. Press
Deviations and Advisories
Solution Solution Solution
to clear alarm.
to clear alarm.
to clear alarm.
to clear alarm.
to clear alarm.
to clear alarm.
Setup Screen 2: Maintenance
44). Press to clear
to clear alarm.
51).
51).
43).
43).
57