ProControl 1KE Plus Models
ProControl 1KE
1KE Plus
ProControl
ProControl
1KE
(Numbered steps 1–4 correspond to the numbered
columns in the
ProControl 1KE Plus Model Selection
Matrix, page 5
.)
1. Choose level of application control needed.
2. Determine flow meter, if applicable for level of
control chosen. (Gun Atomizing Air Control and
Closed Loop Fluid Pressure Control units do not
use a flow meter.)
The G3000 meter is the standard recommended
meter.
Note:
Note: Not all meters are approved for hazardous
Note:
locations. See your flow meter manual for details.
3. Determine fluid pressure regulator, if applicable
for the level of control chosen. (The Gun
Atomizing Air Control unit, 25B289, does not use
a fluid pressure regulator.)
The Graco 24C375 1:1 Low Flow Regulator is
standard.
6
Plus Selection
Selection Guide
Guide
Plus
Selection
Guide
4. Select base ProControl 1KE Plus model part
number from the
ProControl 1KE Plus Model
Selection Matrix, page 5
Note
ProControl 1KE Plus units come with 5 ft.
(1.5 m) cable lengths to allow mounting
the user control interface (ADCM) near the
fluid panel. If a more remote mounting is
required, purchase the appropriate extension
cables, available in 50 ft. (16 m) lengths.
See
Accessories, page
.
77.
3A6948A