Table of Contents
Advertisement
28/139
Bosch Rexroth AG
Mounting the Field Bus Coupler
5.4
Direct Mounting on System
5.5
Mounting on Carrier Rail (only with Bosch Rexroth Accesso‐
ries)
5.5.1
Fastening Carrier Rail Adapter on Field bus Coupler
Rexroth IndraControl S67 Sercos Coupler 8 Digital Inputs (M8)
or
●
Profile adapters including fastening screws
●
Spacer (optional)
Three M4x12 screws are required for direct mounting of the field bus coupler.
Select the length of the screw shaft with regard to the fastening type.
Drilling dimensions
When fastening the IndraControl S67 component without a threaded hole,
the clearance hole must not be wider than 4 mm to ensure a safe contact of
the FE connections.
Mount field bus coupler without using of Bosch Rexroth accessories directly
on a flat surface of the system. Direct mounting of the field bus coupler is to
be carried out as follows:
1. Disconnect the power supply from those devices on which the field bus
coupler is to be mounted.
2. Mark the drilling holes. Use the drilling template printed on the packag‐
ing. Alternatively, hold the field bus coupler in the desired position and
mark the drill holes. Ensure that there is sufficient space around the
IndraControl S67 series component to connect all cables without prob‐
lems.
We recommend the use of Bosch Rexroth spacers for compact
direct mounting. If these spacers are used, the additional distance
from the second IndraControl S67 component on is to be ob‐
served (see
chapter 5.8 "Mounting Spacer in Case of Compact
Arrangement" on page
3. Fasten the field bus coupler to the grounded frame of the system or to
another grounding point with the M4x12 screws via the three fastening
holes.
Fig. 5-1:
Mounting the field bus coupler at the grounded frame of the system or
another earth connection point
A carrier rail adapter is required to mount the field bus coupler on carrier rails.
DOK-CONTRL-S67S3BKDI8*-AP03-EN-P
31).
System
Hide quick links:
Advertisement
Table of Contents
