Bosch Rexroth IndraControl S67-S3-BK-DI8-M8 Application Description page 54

52/139 Bosch Rexroth AG
Web-Based Management (WBM)
Rexroth IndraControl S67 Sercos Coupler 8 Digital Inputs (M8)
Procedure:
1. To confirm the entries, click SUBMIT.
2. To clear the entries that have not yet been saved, click RESET.
3. The entered Sercos address is only applied after the software has been
reset. To reset the software, click "Administration" in the navigation bar
and then Software Reset. The power supply of the field bus coupler can
be switched off and on again.
The following table explains the parameters listed on the site:
Status information Description
Communication phase Displays the current Sercos communication phase
Sub-device operating Displays the current operating state of the I/O application
level
Enhanced operating Displays whether the enhanced operating mode is activa‐
mode ted
Activating the enhanced operating mode allows the field
bus coupler to be operated with Sercos communication cy‐
cle times that are below the minimum S-BUS cycle time
Fast digital inputs Displays whether the fast digital inputs integrated in the
field bus coupler are activated
When activated, the digital inputs of the field bus coupler
are cyclically recorded with each Sercos communication
cycle, even if the Sercos communication cycle is shorter
than the minimum S-BUS cycle time
Sercos Electronic label
Component Name These fields display the manufacturer specifications of the
Sercos field bus coupler (electronic type plate); these
Vendor Name
specifications are also located in the Sercos specification
under "function group identification"
Vendor Code
Device Name
Vendor Device ID
Function revision
Hardware revision
Software revision
Firmware loader revi‐
sion
Order number
Serial Number
Manufacturing date
Version of communica‐
tion hardware
Sercos Address (active) Displays the active Sercos address of the field bus coupler
Sercos Address (device Set the Sercos address here
storage)
Tab. 8-5: Describing parameters of the "Sercos Identification" page
DOK-CONTRL-S67S3BKDI8*-AP03-EN-P