Bosch NPD-6001A Installation Manual

High poe midspan 60w, single port, ac in.
Hide thumbs
High PoE Midspan 60W, Sin-
gle port, AC in
NPD-6001A
en

   Also See for Bosch NPD-6001A

   Related Manuals for Bosch NPD-6001A

   Summary of Contents for Bosch NPD-6001A

  • Page 1

    High PoE Midspan 60W, Sin- gle port, AC in NPD-6001A Installation Manual...

  • Page 3: Table Of Contents

    Conventions in this Manual About this Manual Important Safety Instructions Customer Support and Service Unpacking Parts List Additional Parts Required Tools Required Additional Parts Recommended But Not Required System overview Installation Connection Troubleshooting Bosch Security Systems Installation Manual 2013.03 | 1.2 | F.01U.279.929...

  • Page 4: Safety, Conventions In This Manual

    Notice! This symbol indicates information or a company policy that re- lates directly or indirectly to the safety of personnel or protec- tion of property. 2013.03 | 1.2 | F.01U.279.929 Installation Manual Bosch Security Systems...

  • Page 5: About This Manual, Important Safety Instructions

    Because of the ongoing development of products, the content of the manual may change without notice. Bosch Security Systems accepts no liability for damage resulting directly or indirectly from faults, incompleteness, or discrepancies between the manual and the product described.

  • Page 6

    The Data In and Data & Power Out interfaces are qualified as SELV (Safety Extra-Low Voltage) circuits according to IEC 60950-1. These interfaces can only be connected to SELV interfaces on other equipment. Recycling and Disposal: 2013.03 | 1.2 | F.01U.279.929 Installation Manual Bosch Security Systems...

  • Page 7: Customer Support And Service

    European Directive 2002/96/EC. Customer Support and Service If this unit needs service, contact the nearest Bosch Security Systems Service Center for authorization to return and shipping instructions. Service Centers...

  • Page 8

    Telephone: 86 (0) 756 7633117 or 86 (0) 756 7633121 / Fax: 86 (0) 756 7631710 E-mail: customer.service@cn.bosch.com Warranty and additional information For additional information and warranty queries, please contact your Bosch Security Systems representative or visit our website at www.boschsecurity.com. 2013.03 | 1.2 | F.01U.279.929 Installation Manual Bosch Security Systems...

  • Page 9: Unpacking, Parts List, Additional Parts Required

    High PoE Midspan 60W, Single port, AC in 120 V power cord 230 V power cord Installation Manual (this document) Additional Parts Required The following table lists additional parts (not supplied by Bosch) required to install the midspan: Quantity Part Size Notes Mounting Head diameter: 1.5 mm (0.059 in.)

  • Page 10: Tools Required, Additional Parts Recommended But Not Required

    Single port, AC in Tools Required Screwdriver Additional Parts Recommended But Not Required The following table lists additional parts (not supplied by Bosch) recommended to install the midspan: Quantity Part Surge suppressor Splitter Universal Power Supply (UPS) 2013.03 | 1.2 | F.01U.279.929...

  • Page 11: System Overview

    Note: The midspan is not a repeater and does not amplify the Ethernet data signal. Note: The Ethernet cable length must be less than 100 meters from the Ethernet source to the AutoDome camera. Bosch Security Systems Installation Manual 2013.03 | 1.2 | F.01U.279.929...

  • Page 12: Installation

    (NEC)), Canadi- ® an Electrical Code, Part I (also called CE Code or CSA C22.1), and all applicable local codes. Bosch Security Systems, Inc. ac- cepts no liability for any damages or losses caused by incorrect or improper installation. The midspan can be placed on a desktop or mounted on a wall, bench, or shelf using the rear side mounting holes.

  • Page 13

    High PoE Midspan 60W, Installation | en Single port, AC in Bosch Security Systems Installation Manual 2013.03 | 1.2 | F.01U.279.929...

  • Page 14: Connection

    Connect the Data In (input) port to the remote Ethernet network switch. Connect the Data & Power Out (output) port to the Ethernet port on the AutoDome camera. Note: Do NOT use cross-over cable! 2013.03 | 1.2 | F.01U.279.929 Installation Manual Bosch Security Systems...

  • Page 15

    2 Port connectivity indicator 3 CAT5 cable 4 Connection to AutoDome camera 5 Connection to Ethernet switch If desired, connect a splitter close to the terminal, but not on the midspan. Bosch Security Systems Installation Manual 2013.03 | 1.2 | F.01U.279.929...

  • Page 16: Troubleshooting

    - data at 1Hz rate or/and spare, (PD or cable fault) – Blinking yellow – Internal fault condition or green 4Hz rate 2013.03 | 1.2 | F.01U.279.929 Installation Manual Bosch Security Systems...

  • Page 17

    3. Verify that for this link, you are using no data link. standard UTP/FTP Category 5 straight (non- crossover) cabling, with all four pairs. Bosch Security Systems Installation Manual 2013.03 | 1.2 | F.01U.279.929...

  • Page 18

    AutoDome camera. 5. Try to reconnect the camera to a different midspan. If the camera works, then there is probably a faulty port or RJ45 connection on the midspan. 2013.03 | 1.2 | F.01U.279.929 Installation Manual Bosch Security Systems...

  • Page 20

    Bosch Security Systems, Inc. 850 Greenfield Road Lancaster, PA, 17601 www.boschsecurity.com © Bosch Security Systems, Inc., 2013...

Comments to this Manuals

Symbols: 0
Latest comments: