38
Table of Contents
Pos: 34 /Alle Serien (Allgemeine Module)/Überschriften/Neue Überschriften/Ebene 1In Betrieb nehmen - Überschrift 1 @ 4\mod_1240901452750_21.docx @ 31570 @ 1 @ 1
7
Commissioning
Pos: 35 /Serie 750 (WAGO-I/O-SYSTEM)/In Betrieb nehmen/Parametrieren mit WAGO-I/O-CHECK/Parametrieren mit WAGO-I/O-CHECK - Überschrift 2 @ 7\mod_1268645151531_21.docx @ 52473 @ 2 @ 1
7.1
Parameterization with WAGO-I/O-CHECK
Pos: 36 /Serie 750 (WAGO-I/O-SYSTEM)/In Betrieb nehmen/Parametrieren mit WAGO-I/O-CHECK/Konfigurieren und Parametrieren mit WAGO I/O-CHECK 750-0597 @ 25\mod_1453474641487_21.docx @ 199152 @ 3444566554555555444 @ 1
The WAGO-I/O-CHECK software from WAGO Kontakttechnik GmbH & Co.
KG can be used to conveniently and completely configure and parameterize the
I/O module. You have the following options.
•
Graphical display of bus nodes
•
Display of process values
•
Settings for the application
•
Configuration of the I/O module operating modes
•
Parameterization of module, channel and scaling settings
•
Calibration of channels and adjustment of analog outputs
•
Monitoring
WAGO-I/O-CHECK
You can obtain the WAGO-I/O-CHECK software on a CD under Item No. 759-
302. This CD contains all the application program files and an explanation. You
can find a description at the internet page at
Save settings before you being parameterization
You should always save your current settings to a parameter file before you begin
parameterization. This enables you to always use the original values, should any
parameters you are defining not be correct.
Disable active mode before access to parameterization dialog
Monitor and Control modes must be disabled before opening the parameterization
dialog.
WAGO-I/O-SYSTEM 750
750-597 8AO 0-10V/±10V DC
http://www.wago.com
Manual
Version 1.0.0