Table of Contents
Advertisement
Electrically and hydraulically assembling and installing the measuring points
9.3 Hydraulic Test Run after Installation
If not yet fitted: Fitting the hose lines
P_MAZ_0041_SW
Fig. 14: Installing the hose line
Hydraulic installation, bypass fitting
with pipework
46
1.
Cut off the ends of the hoses (6) so that they are straight.
2.
Unscrew the union nut (5) and push over the hose together
with the clamp ring (4).
3.
Push the hose end (6) up to the stop over the nozzle (3).
4.
Tighten the union nut (5).
5.
Pull on the hose (6) and tighten up the union nut (5).
1
Connector
2
Seal
1
3
Nozzle
4
Clamp ring
2
5
Union nut
3
6
Hose line
4
5
6
CAUTION!
Warning of escaping feed chemical
Feed chemical can escape in the event that the
hose lines are incorrectly installed.
–
Only use original hoses with the specified hose
dimensions.
–
Avoid reducing the hose sizes.
Permissible operating conditions
The values for the permissible hydraulic operating
conditions are given on the nameplate.
NOTICE!
Decoupling the measuring plate from oscillations,
vibrations etc.
Put in place appropriate measures to decouple the
measuring plate and on-site pipework from oscilla‐
tions, vibrations, load, bending stress etc., which
can be transmitted by the glued pipes onto the
measuring plate. The operator is responsible for
selecting the appropriate measures.
Advertisement
Table of Contents
