Table of Contents
Advertisement
Electrically and hydraulically assembling and installing the measuring points
Connect the additional hydraulic com‐
ponents outside of the plate (optional)
Free flow
Make sure that the system pressure specified on
the nameplate is not exceeded and that there is no
negative pressure.
Adhering the sample water lines
The manufacturer's specification for the different
materials, such as pipes, adhesive, straight unions
etc., is essential for the design of the adhesive.
1.
Fig. 15: Bypass fitting straight union (1)
Glue the sample water lines provided on site with the straight
unions of the bypass fitting. Refer to the drawing for sizing.
Pay attention to the operating instructions provided for the addi‐
tional operational components outside of the plate when hydrauli‐
cally connecting them.
After successful installation, a hydraulic test run of the
DULCOTROL
®
measuring/control station is essential.
Check the sampling tap. Make sure that the sampling tap is
n
closed, otherwise sample water will escape.
Check all threaded connectors prior to initial commissioning.
n
Open the stopcock/ball valve on the inlet and outlet side.
n
Check the system for leak-tightness. Do not allow any liquids to
n
escape.
Should liquid escape: check the system and repair the leak.
A2124
47
Advertisement
Table of Contents
