Table of Contents
Advertisement
11.2.4
Continuous display
7
6
5
Fig. 27: Continuous display
1
Measured variable (switch using
[ConI] , [RES] , [TDS] and
lowing are possible:
[SAL]
2
Reference temperature or temperature compen‐
sation
3
Control variable
Switching between measured varia‐
bles
11.2.5
Information display
[ESC] ): the fol‐
4
Possible error text: for example
tion of limit value transgression e.g. value below
the limit in this case)
5
Temperature (correction variable)
6
Measured value (actual value)
7
Operating status
The bottom line displays the current measuring temperature and/or
a temperature manually entered. The temperature display cannot
be switched off.
The temperature (measuring temperature or reference tempera‐
ture) is needed to calculate all measured variables, which is why
the second line of the continuous display therefore displays infor‐
mation about temperature compensation and the reference tem‐
perature.
The setpoint is displayed in the Information menu.
Use the
key to switch between the controller's measured varia‐
[ConI] , [RES] , [TDS] and [SAL] in the continuous display.
bles
Depending on the measured variable set, the settings of variables
are changed or the variables are hidden completely in the
[INPUT Ø TCOMP] menu and in the [LIMIT] menu.
The most important parameters for each first-level menu item are
displayed in the information display.
Use
to access the information display from the continuous dis‐
play. Pressing
again calls up the next information display.
Pressing
calls up the continuous display again.
User interface of the controllers
ConI
µS
/cm
[Limit↓] (direc‐
1
2
3
4
A1861
61
Advertisement
Table of Contents
