Table of Contents
Advertisement
11.1.3
Changes the set operating language
Fig. 23: Menu for setting the operating language
11.1.4
Acknowledge fault or warning message
1.
Simultaneously press the keys
ð The controller changes to the menu for setting the oper‐
Language
Language
German
2.
Now using keys
language
3.
Confirm your selection by pressing the key
ð The controller changes back to the continuous display
If the controller recognises an error
the backlight switches to red lighting and the alarm relay is deacti‐
vated. You can access the next value to be set by pressing the
key. In this process, the controller indicates all errors and warn‐
ings. The pending alarm messages can be selected and, if
required, acknowledged/confirmed. If you acknowledge an error,
the alarm relay activates and the backlight switches back to white
light. In the bottom part of the display, the error or warning mes‐
sage that has occurred remains displayed, such as
the cause has been cleared.
In the event of a warning, e.g. the controller signals that a sensor
has not been calibrated yet, further processing using the controller
is possible with or without acknowledgement of the message.
In the event of an error message
that no sensor is connected, then after acknowledgement of the
message, no further processing is possible using the controller.
You must now rectify the error - for this see the chapter on Diag‐
nostics and Troubleshooting.
User interface of the controllers
ating language.
and
you can set the desired operating
and indicates the selected operating language.
[Error] , [e.g.] the controller signals
and
2
A1482
[Error] , the control is stopped,
[Error 01] , until
57
Advertisement
Table of Contents
