1. Pneumatic interfaces
1.5
Instructions on commissioning
Festo P.BE-CPX-EA-EN en 0112NH
The reaction of the pneumatic interfaces can be parame-
trized. The table below gives an overview of the parameters
for the pneumatic interfaces.
Further information on parametrizing can be found in the
system manual or in the manual for the field bus node.
Please note
Activate the wire-fracture monitoring only for outputs
which also have a valve solenoid coil.
If the wire-fracture monitoring is activated for an output
which does not have a valve solenoid coil, the CPX terminal
will register the error "Wire fracture" when it is switched
on, due to the valve solenoid coil being incorreectly regis-
tered as defective.
1-13