Festo CPX Electronic Manual page 90

4. Output modules
Module parameters
Monitoring the CPX module
Monitoring short circuit in the
outputs
Monitoring the CPX module
Monitoring V (undervoltage
OUT
in load supply outputs)
Reaction after short circuit
Reaction after short circuit in the
outputs
4)
Idle mode channel x
Idle mode channel x
4)
Idle state channel x
Idle state channel x
1)
Fail safe channel x
Fault mode channel x
1)
Fail safe channel x
Fault state channel x
1)
Force channel x
Force mode outputs of channel x
1)
Force channel x
Force state outputs of channel x
1)
m = Module number (0...10, counting on the modules from left to right, beginning with 0)
x = Channel number (0...3 for CPX-4DA)
2)
Default setting
3)
Detailed description see "Diagnosis," Tab. 4/8
4)
Only relevant for certain field bus protocols
5)
Access is protocol-specific (see manual for field bus node)
Tab. 4/7: Parameters of the output modules
4-12
Parameters of the output modules type CPX-4DA
Function no.
1)
4828 + m * 64
1)
4828 + m * 64
1)
4828 + m * 64 + 1
5)
–
5)
–
5)
–
Bit Value range
1 0 = Inactive
2)
1 = Active
2 0 = Inactive
2)
1 = Active
1 0 = Leave voltage switched off
1 = Switch voltage on again
– 0 = Hold last state
2)
1 = Idle state
2)
– 0 = Reset output
1 = Set output
– 0 = Hold last state
2)
1 = Fault state
2)
– 0 = Reset output
1 = Set output
2)
– 0 = Blocked
1 = Force state
2)
– 0 = Reset signal
1 = Set signal
Festo P.BE-CPX-EA-EN en 0112NH
2)
3)