Festo CPX Electronic Manual page 32

1. Pneumatic interfaces
Module parameters
Monitoring the CPX module
Monitoring Vout (outputs)
Monitoring the CPX module
Monitoring short circuit in the valve supply
Monitoring wire fracture channel x
Channel 0...7:
Channel 8...15:
Channel 16...23:
Channel 24...31:
3)
Idle mode channel x
Idle mode channel x
3)
Idle mode channel x
Idle state channel x
1)
Fail safe channel x
Fault mode channel x
1)
Fail safe channel x
Fault state channel x
1)
Force channel x
Force mode outputs of channel x
1)
Force channel x
Force state outputs of channel x
1)
m = Module number (1...10; Counting on the modules from left to right, beginning with 0)
x = Channel number (valve number; 0...25: Midi/Maxi, 0...21: CPA)
2)
Default setting
3)
Only relevant for certain field bus protocols
4)
Access is protocol-specific (see manual for field bus node)
Tab. 1/4: Parameters of the pneumatic interfaces
1-14
Parameters of the pneumatic interfaces
typ CPX-GP-03-4.0 and CPX-GP-CPA-...
Function no.
4828 + m * 64
4828 + m * 64
1)
4828 + m * 64 + 6
4828 + m * 64 + 7
4828 + m * 64 + 8
4828 + m * 64 + 9
4)
–
4)
–
4)
–
Bit Value range
1)
2 0 = Inactive
1 = Active
1)
3 0 = Inactive
1 = Active
0...7 0 = Inactive
1)
1 = Active
1)
1)
1)
– 0 = Hold last state
1 = Idle state
– 0 = Reset output
1 = Set output
– 0 = Hold last state
1 = Fault state
– 0 = Reset output
1 = Set output
– 0 = Blocked
1 = Force state
– 0 = Reset signal
1 = Set signal
Festo P.BE-CPX-EA-EN en 0112NH
2)
2)
2)
2)
2)
2)
2)
2)
2)