Festo CPX Electronic Manual page 132

A. Technical appendix
Connecting the plugs
and cables
1 Cables
2 Strain relief
3 Housing
4 Connecting part
Knurled nut
5
6 Thread for connector
socket with knurled
nut
Fig. A/7: Individual parts of plug and cable exit
A-20
Connect the plugs and cables as follows (example):
1. In order to open the sockets loosen the centre knurled
nut.
2. Open the strain relief on the rear part of the housing.
Then pass the cable through.
1
6
3. Remove 5 mm of insulation from the end of the cable and
fit end sleeves on the strands.
4. Connect the ends of the conductor.
5. Replace the connecting part on the housing of the socket.
Pull the cable back so that there are no loops inside the
housing.
6. Tighten the strain relief.
2
3
4
5
Festo P.BE-CPX-EA-EN en 0112NH