Figure 5-1 Single Cpu Variant; Table 5-2 Dual Cpu Variant - SMART Embedded Computing MC1600 Installation And Use Manual

Software Configuration
Table 5-2
CPU Interface
ETH1
CPU1
bcm
xlink
ETH2
CPU2
bcm
xlink
When CPU1 boots, a DHCP configuration is created and the DHCPD service is started.
This allows CPU2 to PXE boot from CPU1. See the following figures for the single and dual
default network diagrams.

Figure 5-1 Single CPU Variant

ETH1 = 172.26.1.10
ETH2 = not configured
98
Dual CPU Variant
Description
Front panel interface
Network interface from CPU1 to the Broadcom switch Not configured
Network interface to CPU2
Front panel interface
Network interface from CPU2 to Broadcom switch
Network interface to CPU1
ETH1
ETH2
Front
Panel
CPU 1
bcm interface
Broadcom Switch
MC1600 Extreme Edge Server Installation and Use (6806870A02B)
Software Configuration
Default IP
Address
172.26.1.10
172.27.1.10
172.26.1.20
Not configured
DHCP enabled