SMART Embedded Computing MC1600 Installation And Use Manual page 106

Software Configuration
Here is example output for the ps command on the Extreme Edge Server:
BCM.0 ps
port
xe0(
2)
xe1(
3)
xe2(
4)
xe3(
5)
xe4(
6)
xe5(
7)
xe6(
8)
xe7(
9)
BCM.0>
Notice the ports are labeled xe0 through xe7. The xe0-xe4 ports correspond to the SFP+
front panel ports labeled ETH 3 through 7. The connections to CPU1 & CPU2 are xe5 and
xe7. The BMC link is xe6.
If a (slower) 1G SFP module, copper or fabric, is inserted into any of the front panel SFP
ports, then the corresponding port must be reconfigured with auto-negotiation turned on,
using the BCM utility. For example, if a 1G SFP copper module is inserted in ETH 7 (xe4):
BCM.0> port xe4 autoneg=on
To capture statistic (packet) counters for a particular, or group of ports, use the show
command. For example, the following command displays counters for ports xe5 & xe6:
BCM.0> show c xe5-xe6
To transmit dummy packets from a specific port, use the tx command. For example, the
following command transmits 1000 packets on port xe0, assuming the link is up:
BCM.0> tx 1000 pbm=xe0
To display the currently configured VLANs, use the vlan show command. For example:
BCM.0> vlan show
106
ena/ speed link auto
link /dupl scan neg?
ex
down - HW Yes
down - HW Yes
down - HW Yes
down - HW Yes
down - HW Yes
up 10G HW Yes
FD
up 1G FD HW Yes
down - HW Yes
MC1600 Extreme Edge Server Installation and Use (6806870A02B)
STP
state
pause discr
d
Forwar TX RX None
d
Forwar TX RX None
d
Forwar TX RX None
d
Forwar TX RX None
d
Forwar TX RX None
d
Forwar TX RX None
d
Forwar None
d
Forwar TX RX None
d
Software Configuration
lrn inter max loop
ops face frame back
FA SGMII 16356
FA SGMII 16356
FA SGMII 16356
FA SGMII 16356
FA SGMII 16356
FA KR 16356
FA KX 16356
FA SGMII 16356