Advertisement
View of the assembled unit ready to mount
in the frame. Note that the curved contour
in the lower ball bearing block D608 must
be on the left side (view in flight direction).
Attach the lower ball bearing block D608
on the upper right frame D602 with two
hex bolts M3x6 D196 using Loctite. Tigh-
ten the bolts first if the screws of the upper
mainshaft bearing block D607 are also
mounted.
Attach the upper ball bearing block D607
with two hex bolts M3x6 D196 still without
Loctite and tighten it only a bit, because
later you must open the bearing block
again to insert the elevator servo in its
slot.
After tightening the four screws check the
mainshaft for easily turning without any
endplay.
Advertisement
