Advertisement
Finally add the blue marked grooved shim
with the inner diameter of 8.0mm (does
not tilt on the spindle).
Add (a) washer shim(s) and a ball bearing
8x16x5 071. The necessary thickness of
washer shims can vary a bit and must be
checked by everyone for himself. There-
fore both sides of maingrip units must be
mounted and the M5x12 hex bolts 034
and washer shims 5x10x1 052 will be
mounted from hand(!). If you feel end play
then add 0.1mm on each side. If the bea-
rings become notchy then remove 0.1mm
each. You can also mount 0.1mm only on
one side if necessary.
If the end play is correct then apply Locti-
te to the threads of both hex bolts M5x12
034 and tighten them from hand first.
Then tighten the screws with 8-10 Nm
about (if you have a torque driver). If not
then „tighten, but no too tightened"). Note
that a too high tightened bolt reduces
the total strengthness of the bolt that can
cause a damage.
Advertisement
