Advertisement
A hex bolt M3x16 D329 ist pushed into the
belt tightening lever D614 and a washer
shim 3x6x0.2 455 will be added.
The fixed roller is now screwed with Loc-
tite into the right hole of the lower mast be-
aring block (seen in flight direction). After
tightening the screw all bearings will be
checked for clearness.
The premounted belt tightening lever will
be screwed with Loctite into the left hole
of the lower mast bearing block (seen in
flight direction). Please check before that
the washer shim 3x6x0.2 455 is placed
between the upper bearing of the lever
and the lower mast bearing block. After
tightening check the lever for easy turning.
The dampening rubber ring D617 will be
placed on the two grooves of the rubber
ring holders.
Advertisement
