Advertisement
Attach the elevator servo linkage as
shown. Mount the servo arm hex bolt
M3x8 D197 and the washer shim 3x6x1
051 using Loctite also later when the
servo is under electric current and has its
defined center position.
Attach the swash plate holder D532 with
two hex bolts M3x12 D119 using Loctite.
Assemble the tail servo arm. Recomen-
ded arm length is 17-18.5mm. Attach a
hex bolt M2x12 099, a ball D117 and a
washer M2 001 on the not toothed side of
the servo arm and add on the other side a
washer M2 001 and a lock nut M2 007. A
hex bolt M3x8 D197 and a washer 3x6x1
for locking the servo arm on the servo will
be attached later when the servo is under
current and has its center position.
Two tail servo mounting blocks D629 are
attached gently with four hex bolts M3x12
D119 and washers M3 002 using Loctite.
The rubber grommets of the servo should
be in straight position after tightening the
screws.
Advertisement
