Advertisement
The unit will be fixed thru a hex bolt M3x8
D197 with a large washer M3 004 and
enough Loctite.
For tightening put in a wrench or a shaft
into the center bore of the hub. Recom-
mended torque is 1.5Nm.
Push the tailrotor blade grip 951 on the
unit corresponding with the cross holes of
the blade grip mount ring 980.
Each blade grip is now fixed with two hex
bolts M2,5x5 and distance bushes 988
using Loctite. Before tightening them pull
the blade grips outside so that both are
corresponding with the screws.
Advertisement
