Advertisement
Push the threaded end into the pushrod so
that about 7-8mm free end should be out.
Remove the unnecessary resin careful.
If you use long time hardening resin you
can speed up the hardening using a heat
gun or a hairdryer. Therefore only the
threaded end should be heated, not the
carbon rod. Check that the threaded end
does not move during hardening because
the resin will become very liquid for a short
time.
After the resin has hardened turn a ball
joint 041 fully on the thread.
Add a pice of shrink tube on the ball joint
and the carbon rod to enlarge stiffness.
This side of the tail pushrod is later placed
at the rear end (on the bell crank D49).
Advertisement
