Advertisement
The arms of the swashplate servos should
have an effective length of about 17mm.
You can use f.e. the optional servo arms
D154a. Attach a hex bolt M2x10 D296, a
joint ball D117 and a washer M2 001 on
three servo arms. The elevator servo arm
gets these parts from the not toothed side.
On the otherside of the arm put a washer
M2 001 and a lock nut M2 007 on the bolt.
The roll servo arms get these parts from
the toothed side. On the otherside of the
arms put a washer M2 001 and a lock nut
M2 007 on each bolt.
Push a rubber grommet D80 that is cutted
from one side on the elevator servo cable,
put the plug into the hole of the upper right
frame D602 and press the grommet into
the hole.
Put the swashplate justation ring D631 on
the mainshaft, followed from the swash-
place that must have contact to the justati-
on ring.
Advertisement
