Advertisement
... and finally the lower rear connector.
View of the mounted unit.
The front tailboom holder clamp D620 is
attached with two hex bolts M3x6 D196.
Apply Loctite only on the upper screw. On
the lower screw Loctite will be applied la-
ter after tightening the long tailboom tigh-
tening screws (long slot in the frame) and
as long it will be loose. The front holder is
not anodized to guarantee electric con-
duction between boom and frame. Check
if a 3mm thick aluminum spacer D620a is
placed under the long screw M3x35 D338.
The rear tailboom holder clamp D620s is
attached with two hex bolts M3x6 D196.
Here the upper bolt will be tightened with
Loctite too and the lower bolt is still kept
loose without Loctite.
Advertisement
