Advertisement
Now place the upper right frame D601
on the unit and check all holes for correct
corresponding.
Add four hex bolts M3x6 D196 on the tail-
boom clamps with Loctite but still do not
tighten them.
Attach the upper front frame connector
using two hex bolts M3x6 D196 and Loc-
tite. Keep it still loose. Connect the frame
with the upper mainshaft bearing block
D607 using two hex bolts M3x6 D196
without Loctite and keep it also still loose.
Use no Loctite here because the upper
mainshaft bearing block will be loosed la-
ter again for mounting the elevator servo.
Add the cover plate D603 and check for
corresponding holes.
Advertisement
