Advertisement
The roll servo is attached with four hex
bolts M3x12 D119, washers M3 002 and
lock nuts M3 008s. Therefore the open
wrench #707 is a very good tool. The lo-
wer right screw will be applied with Loctite
and turned then in the connector D622.
After gently tightenimng of the bolts the
provisorically mounted single bolt on the
right side can be removed.
Place the right roll servo. Both servo
cables should go in a big arc backwards.
They can tough the cover plate on the up-
per first stage bearing block (this is inten-
ded). Tighten the screws as well as the left
roll servo.
Cut a rubber grommet D80 on one side
with a scissors. This is necessary to put it
on the servo cable.
Put both roll servo cables thru the big hole
of the vertical frame stiffener D623.
Advertisement
