Advertisement
Push a hex bolt M3x16 D329 thru the
bearings of the bell crank D49 and add a
washer shim 3x6x1 051and apply some
Loctite on the thread...
... and mount the bellcrank on the rudder
fin holder D49. Note that the ball of the
tailslider 1475 must be pushed into the
ball guilde bush D288.
For mounting the threaded ends 087 on
the tail pushrod 0350 mix some JB Weld.
Apply the resin on the side of the first
threaded end that was cutted with a saw.
and put also a bit of resin into the hole of
the tail pushrod.
Advertisement
