Advertisement
Put the mainrotor shaft D605 into the
mainwheel hub, put a jesus bolt D77
through both and tighten the bolt well with
a lock nut M4 009. If the screw does not
easily fit then turn the shaft in the hub 180
degree and try again.
Push the spacer bush D606 on the shaft.
Push the upper main shaft bearing plate
D607 on the mainshaft. The flange of the
ball bearing D71a must show to the spa-
cer bush.
Push the lower mainshaft bearing block
D608 on the lower end of the mainshaft.
The flange of the ball bearing D71a must
show to the main gearwheel D13.
Advertisement
