Advertisement
View of the mounted unit. Both blade grips
should turn easily and a small end play is
recommended to keep both thrust bearing
without any load. If this is not the case
then disassemble the unit and shorten the
conic bushes a bit using a file or sandpa-
per. If the endplay is too much then use a
0.1mm washer shim that you place bet-
ween inner bearing and blade grip mount
ring.
Attach a joint bolt M3x9 078 into each
blade grip using Loctite. Recommended
torque 1.1 Nm.
The tailrotor blades will be hold from a hex
bolt M3x25 D336, two chinese weights
952 and a lock nut M3 008s.
View of the ready mounted tailrotor.
Advertisement
