Advertisement
View of the mounted mechanic
Bag 9: Tailboom
Parts overview
Remove some anodized black surface
from the front end of the tailboom D639
(the side without slots) with a small flat file
to get a good grounding between tail and
mainframe. For this reason the front tail-
boom clamp is not anodized. Then push
the tailboom careful in the clamps. Be cau-
tious that you do not damage any servo
cable.
Pull the tailbelt 286 either with a long cran-
kes wire thru the boom or use a thin rope
with a weight at the end (f.e. a big nut).
Check that the belt is not turned in anyway
in the tailboom. Then put a finger from
above in the belt end...
Advertisement
